Replacing Brinks with Vista 20p with zone expander

I’m replacing a Brinks alarm system and I have a few questions. The existing setup is all wired:

Brinks BHS-3000C panel with 3 keypads

2 int. sirens/speakers

1 ext. siren

1 ext. strobe

zone 1 – 2 doors

zone 2 – 2 int. doors

zone 3 – 7 windows

zone 4 – 1 overhead door

zone 5 – 4 overhead doors

zone 6 – 4 glassbreaks

zone 7 – 1 smoke, 1 heat

zone 8 – 1 smoke, 1 heat

Honeywell 4208u zone expander

zone 9 – 1 motion

zone 10 – 1 motion

For the new alarm, I’ve purchased:

Honeywell Ademco Vista 20p control panel

Honeywell 6160 alpha keypad

2 Honeywell 6150 fixed keypads

Honeywell 4219 zone expander

1. The panel is upstairs and the zone expander is mounted downstairs next to one of the motion detectors, and from there it’s wired to the main keypad. Can I use this same wiring setup with the new zone expander?

2. The motions are both connected to the zone expander. When I connect them to the new expander, will each need a EOL resistor?

3. Does it matter which zone/connectors the motions are connected to on the new expander? Where I mounted the new expander, I can only reach the two right most zone connectors.

4. It looks like the glassbreaks are wired/looped together. Is it ok to leave them like that when I connect them to the new alarm panel? Do I just need one EOL resistor?




Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s